Motif for fingernails with colour gel in mint

You need:
1. Gel cleanser to remove sticky gel residues after UV treatments
2. Pads
3. Nail art liner in “dark Green”
4. Nail art liner in “Fuchsia-Glitter”
5. Finishing gel
6. Finishing gel brush
7. Colour gel in mint
8. Colour gel in white
9. Nail file
10. Thin nail art brush
11. Spot-swirl

12. UV light

Abrade the fingernail surface for preparation with a fine nail file, as left in the pictures shown.

Note:
You have to abrade the fingernail surface for better adhesion of the colour gel.

Tip:
We recommend to begin with the thumb, because it has a larger working surface.

Step 1: Spot-Swirl and the colour gel in mint
Dip the spot-swirl somewhat into the colour gel in mint.

Note:
Don’t touch the fingernail surface with the spot-swirl. When you apply the colour, the spot-swirl has to hover above the fingernail surface, as left in the pictures shown.

Begin on the left edge of the fingernail and draw with the colour gel in mint a line to the right fingernail tip.

Now paint the lower side of the fingernail with the colour gel in mint, as left in the pictures shown.

Tip:
If you have synthetic fingernails you should pay attention that the edge of the fingernail is also painted. This causes a perfect and consistent look of the fingernail.

The result should correspond approximately to the picture on the left side.

Step 2: UV light, a pad and the gel cleanser to remove sticky gel residues
Adjust the timer of the UV light at 120 seconds and put the finger careful as far as possible into the UV light.

Turn the UV light on and wait until the timer turns it off.

Apply the gel cleanser on a pad and remove the sticky gel residue, as left in the pictures shown.

Step 3: Nail art liner in the colour dark green
Draw with the nail art liner in the colour dark green a long swung line at the transition of the free fingernail surface and the colour gel in mint, as left in the pictures shown.

Tip:
Before you use the nail art liner, you should strip the surplus lacquer of the brush at the edge of the bottle. Thus you can draw clean, fine lines.

Draw with the nail art liner two small oval forms to the long line, as left in the pictures shown.

Now fill the inner surface of the oval forms with the nail art liner in the colour dark green.

The motif for fingernails with colour gel in mint should correspond approximately to the picture.

Step 4: Nail art brush and the colour gel in white
Dip the tip of the nail art brush into the colour gel in white.

Begin on the free fingernail surface and draw three small oval forms at the end of the long line.

Now fill out the inner surfaces of the small oval forms with the white colour gel, as left in the pictures shown.

The motif for fingernails with colour gel in mint should correspond approximately to the picture.

Step 5: UV light, a pad and the gel cleanser to remove sticky gel residues
Adjust the timer of the UV light at 120 seconds and put the finger careful as far as possible into the UV light.

Turn the UV light on and wait until the timer turns it off.

Apply the gel cleanser on a pad and remove the sticky gel residue.

Step 6: Nail art liner in the colour fuchsia-glitter
Now border with the nail art liner in the colour fuchsia-glitter the oval forms in white.

The motif for fingernails with colour gel in mint should correspond approximately to the picture.

Note:
Before you continue with step 7, wait until the nail lacquer on the fingernail is dried.

Step 7: Finishing gel and the finishing gel brush
Dip the tip of the brush into the finishing gel.

Now apply evenly the finishing gel on the complete fingernail surface. The finishing gel protects the motif and gives it more brilliance, as left on the pictures shown.

Note:
Pay attention that the finishing gel is applied on the edge of the fingernail. This protects also the tip of the fingernail.

Step 8: UV light, a pad and the gel cleanser to remove sticky gel residues
Adjust the timer of the UV light at 120 seconds and put the finger careful as far as possible into the UV light.

Turn the UV light on and wait until the timer turns it off.

Apply the gel cleanser on a pad and remove the sticky gel residue, as left in the pictures shown.

The nail art motif for fingernails with colour gel in mint should correspond approximately to the picture.