Fingernail design step by step

You need:
1. Nail lacquer in “bright Beige”
2. Nail art liner in “dark Green”
3. Nail art pen in “Lavender”
4. Nail art liner in “Green-Glitter”
5. Cutter
6. Clear nail lacquer
7. Clear adhesive tape
8. Tweezers

Tip:
We recommend to begin with the thumb, because it has a larger working surface.

Step 1: Clear adhesive tape, the cutter and the tweezers
Cut for preparation a piece clear adhesive tape. Take up the piece of the tape with the tweezers and stick it diagonally on the fingernail.

Press with the tweezers the tape firmly at the surface of the fingernail.

The result should correspond approximately to the picture.

Step 2: Nail lacquer in the colour bright beige
Now paint the free fingernail surface with the nail lacquer in the colour bright beige.

The result should correspond approximately to the picture.

Note:
Before you continue with step 3, wait until the nail lacquer on the fingernail is dried.

Step 3: Nail lacquer in the colour bright beige
Paint another layer nail lacquer on the first layer which is already dried. If you use a bright nail lacquer, you should always paint another layer in the same colour, so that the nail surface does not through-gleam.

Tip:
If you have synthetic fingernails you should pay attention that the edge of the fingernail is also painted. This causes a perfect and consistent look of your fingernail.

The result should correspond approximately to the picture.

Note:
Before you continue with step 4, wait until the nail lacquer on the fingernail is dried.

Step 4: Tweezers
Remove carefully with the tweezers the clear adhesive tape.

The result should correspond approximately to the picture.

Step 5: Nail art liner in the colour dark green
Start approximately in the middle of the fingernail and draw with the nail art liner in dark green a curved line on the transition of the nail lacquer and the free fingernail surface.

Tip:
Before you use the nail art liner, you should strip the surplus lacquer of the brush at the edge of the bottle. Thus you can draw clean, fine lines.

Now draw with the nail art liner at the long line a short curved line.

The fingernail design step by step should correspond approximately to the picture.

Note:
Before you continue with step 6, wait until the nail lacquer on the fingernail is dried.

Step 6: Nail art pen in the colour lavender
Draw with the nail art pen in the colour lavender three small points at the upper end of the long line.

Draw with the nail art pen two small points below the three small points.

Draw with the nail art pen a small point below the two small points.

Draw with the nail art pen three small points at the short curved line.

Draw with the nail art pen two small points below the three small points.

Now draw with the nail art pen a small point below the two small points.

The fingernail design step by step should correspond approximately to the picture.

Note:
Before you continue with step 7, wait until the nail lacquer on the fingernail is dried.

Step 7: Nail art liner in the colour green-glitter
Now draw with the nail art liner in the colour green-glitter four short curved lines at the long line.

The fingernail design step by step should correspond approximately to the picture.

Note:
Before you continue with the last step, wait until the nail lacquer on the fingernail is dried.

Step 8: Clear nail lacquer
At the last step you have to paint over the entire fingernail with a clear nail lacquer.

The clear nail lacquer protects the nail art and gives the fingernail more gloss.

After the clear nail lacquer is dried, the fingernail design step by step is finished.