Nail art motif in red with colour gel

You need:
1. Gel cleanser to remove sticky gel residues after UV treatments
2. Pads
3. Finishing gel
4. Finishing gel brush
5. Colour gel in red
6. Colour gel in white
7. Nail file
8. Thin nail art brush
9. Spot-swirl

10. UV light

Abrade the fingernail surface for preparation with a fine nail file, as left in the pictures shown.

Note:
You have to abrade the fingernail surface for better adhesion of the colour gel.

Tip:
We recommend to begin with the thumb, because it has a larger working surface.

Step 1: Spot-Swirl and the colour gel in red
Dip the spot-swirl somewhat into the colour gel in red.

Note:
Don’t touch the fingernail surface with the spot-swirl. When you apply the colour, the spot-swirl has to hover above the fingernail surface, as left in the pictures shown.

Apply the colour gel in red on the complete fingernail surface, as left in the pictures shown.

Tip:
If you have synthetic fingernails you should pay attention that the edge of the fingernail is also painted. This causes a perfect and consistent look of your fingernail.

The result should correspond approximately to the picture on the left side.

Step 2: UV light, a pad and the gel cleanser to remove sticky gel residues
Adjust the timer of the UV light at 120 seconds and put the finger careful as far as possible into the UV light.

Turn the UV light on and wait until the timer turns it off.

Apply the gel cleanser on a pad and remove the sticky gel residue, as left in the pictures shown.

Step 3: Nail art brush and the colour gel in white
Dip the tip of the nail art brush into the colour gel in white.

Begin approximately at the centre of the left edge of the fingernail and draw a zigzag line to the right edge of the fingernail.

The nail art motif in red with colour gel should correspond approximately to the picture.

Step 4: UV light, a pad and the gel cleanser to remove sticky gel residues
Adjust the timer of the UV light at 120 seconds and put the finger careful as far as possible into the UV light.

Turn the UV light on and wait until the timer turns it off.

Apply the gel cleanser on a pad and remove the sticky gel residue.

The nail art motif in red with colour gel should correspond approximately to the picture.

Step 5: Finishing gel and the finishing gel brush
Dip the tip of the brush into the finishing gel.

Now apply evenly the finishing gel on the complete fingernail surface. The finishing gel protects the motif and gives it more brilliance, as left on the pictures shown.

Note:
Pay attention that the finishing gel is applied on the edge of the fingernail. This protects also the tip of the fingernail.

Step 6: UV light, a pad and the gel cleanser to remove sticky gel residues
Adjust the timer of the UV light at 120 seconds and put the finger careful as far as possible into the UV light.

Turn the UV light on and wait until the timer turns it off.

Apply the gel cleanser on a pad and remove the sticky gel residue, as left in the pictures shown.

The nail art motif in red with colour gel should correspond approximately to the picture.