Colour gel motif for carnival

You need:
1. Gel cleanser to remove sticky gel residues after UV treatments
2. Pads
3. Nail art liner in “Black”
4. Finishing gel
5. Finishing gel brush
6. Glitter gel in red
7. Colour gel in white
8. Nail file
9. Thin nail art brush
10. Flat brush (Number: 7)

11. UV light

Abrade the fingernail surface for preparation with a fine nail file, as left in the pictures shown.

Note:
You have to abrade the fingernail surface for better adhesion of the colour gel.

Tip:
We recommend to begin with the thumb, because it has a larger working surface.

Step 1: Flat brush and the glitter gel in red
Dip the tip of the flat brush into the glitter gel in red.

Apply the glitter gel in red on the lower half of the fingernail, as left in the pictures shown.

Tip:
If you have synthetic fingernails you should pay attention that the edge of the fingernail is also painted. This causes a perfect and consistent look of your fingernail.

The result should correspond approximately to the picture. on the left side.

Step 2: UV light, a pad and the gel cleanser to remove sticky gel residues
Adjust the timer of the UV light at 120 seconds and put the finger careful as far as possible into the UV light.

Turn the UV light on and wait until the timer turns it off.

Apply the gel cleanser on a pad and remove the sticky gel residue, as left in the pictures shown.

Step 3: Nail art brush and the colour gel in white
Dip the tip of the nail art brush into the colour gel in white.

Draw an eye mask for carnival on the free fingernail surface, as left in the pictures shown.

Now fill out the inner surface of the eye mask with the white colour gel, as left in the pictures shown.

The result should correspond approximately to the picture.

Step 4: UV light, a pad and the gel cleanser to remove sticky gel residues
Adjust the timer of the UV light at 120 seconds and put the finger careful as far as possible into the UV light.

Turn the UV light on and wait until the timer turns it off.

Apply the gel cleanser on a pad and remove the sticky gel residue.

The colour gel motif for carnival should correspond approximately to the picture.

Step 5: Nail art liner in the colour black
Border the eye mask with the nail art liner in the colour black, as left in the pictures shown.

Tip:
Before you use the nail art liner, you should strip the surplus lacquer of the brush at the edge of the bottle. Thus you can draw clean, fine lines.

The colour gel motif for carnival should correspond approximately to the picture.

Draw with the nail art liner in black two eyes into the mask, as left in the pictures shown.

Now fill out the inner surface of the eyes with the nail art liner, as left in the pictures shown.

The colour gel motif for carnival should correspond approximately to the picture.

Note:
Before you continue with step 6, wait until the nail lacquer on the fingernail is dried.

Step 6: Finishing gel and the finishing gel brush
Dip the tip of the brush into the finishing gel.

Now apply evenly the finishing gel on the complete fingernail surface. The finishing gel protects the motif and gives it more brilliance, as left on the pictures shown.

Note:
Pay attention that the finishing gel is applied on the edge of the fingernail. This protects also the tip of the fingernail.

Step 7: UV light, a pad and the gel cleanser to remove sticky gel residues
Adjust the timer of the UV light at 120 seconds and put the finger careful as far as possible into the UV light.

Turn the UV light on and wait until the timer turns it off.

Apply the gel cleanser on a pad and remove the sticky gel residue, as left in the pictures shown.

The colour gel motif for carnival should correspond approximately to the picture.